If your shop still depends on hand tapping or a CNC machine’s rigid tapping cycle for threading holes, a dedicated tapping machine changes how that work gets done.
AXIOS Machines’ TR Series runs on a Mitsubishi 3-phase servo motor with a Mitsubishi PLC controller and a 1700mm working arm radius, letting the operator tap threads accurately without needing the high-end tool holders that CNC tapping usually demands. This is a genuine tapping machine industrial solution, built for shops that tap dozens or hundreds of holes daily and can’t afford the slower cycle times of doing it on a CNC or by hand.
AXIOS Machines is recognised as one of the largest tapping machine manufacturers in India, with a product range built specifically around this kind of daily industrial threading work. We have been working closely with structural steel fabricators, PEB manufacturers, bridge fabrication units and shipyards — industries where threaded holes have to hold load reliably. Our tapping machines run on a flexible or swing arm design with a 360° universal head, so the same machine handles horizontal tapping, vertical tapping, or angled work without needing a different setup each time.
A smart way to use this machine is as part of a drilling cum tapping machine setup — not as one combined unit, but as a tapping arm working right beside your CNC drilling machine, tapping holes while the CNC continues running its own cycle with the same operator. This effectively brings tapping cost and added cycle time close to zero, since you’re not paying for separate CNC tapping time or a dedicated tapping operator.
For shops handling higher volumes, this same arrangement scales into what buyers search for as a multi spindle drilling tapping machine setup, where multiple tapping stations work through a batch of drilled parts continuously. We are one of the reputed tapping machine suppliers in India. Our machines use bearing-supported hinges, so joints move smoothly for years without needing lubrication, and a planetary gearbox with helical teeth keeps backlash low even at high torque. Magnetic alignment adaptors help set the head at the exact angle needed for the drilled hole, which matters a lot when you’re not tapping straight down.
Tapping on a CNC machine (rigid tapping, G84 process) needs high-end tool holders and a highly skilled operator, which adds cost and cycle time. A dedicated tapping machine uses simple quick-change adaptors and can run alongside the CNC with the same operator, cutting tapping time and cost significantly.
Our range covers M12 up to M48, so whether you’re tapping small fasteners or large structural threads, there’s a model built for that capacity.
Yes, the 360° universal head lets you set the tapping angle as needed, so the same machine handles vertical, horizontal, or angled tapping jobs.
It’s used when a component needs several holes tapped close together — running multiple tapping arms in parallel speeds up the job without the cost of a dedicated multi-spindle CNC machine.
Structural steel fabrication, PEB manufacturing, bridge fabrication, shipbuilding, and general heavy engineering, along with MEP contractors needing consistent threading on fittings.
Check the arm radius, motor type (servo vs stepper), and tapping capacity range offered, and confirm whether the manufacturer provides genuine Mitsubishi components, since motor quality directly affects torque and machine life.